Home/Field Notes/How to Build a Wooden Tower for a Box Blind

How to Build a Wooden Tower for a Box Blind

Drop four pressure-treated 4×4 posts into the blind floor's post pockets, lag them in, X-brace all four sides with 2×4s cut to a measured center mark, then flip it upright and level the floor. NXTGen publishes the exact bracing measurements for 8, 10 and 12 foot towers.

Setup & Towers · By NXTGen Hunting Blinds · Published · Updated

Draft Preview — Not Public. This Field Note is saved as a draft and hidden from search engines, the Field Notes hub, and site page placements until published in the Website Dashboard.

What you need

  • Four pressure-treated 4×4 posts, cut to the tower height you want
  • Eight 2×4s (two per side) for X-bracing — length depends on tower height, see the chart below
  • The supplied 4" lag screws for fastening the posts to the floor
  • 3" exterior screws to join each pair of bracing 2×4s at the center mark, and to fasten the braces to the posts
  • An impact driver, a tape measure, a 4 ft level and a second person

Every NXTGen floor has four 4×4 post pockets built in, so there is nothing to fabricate at the top of the tower. A wooden tower works with a side entry or a bottom entry blind.

Step 1 — Floor upside down, posts in

Lay the floor bottom side up. Push the four 4×4 posts all the way into the pockets. Each post should sit tight against the front and back of its pocket.

Step 2 — Lag the posts

Using the supplied 4" lag screws, fasten each post to the floor with one lag on each side of the post.

Step 3 — Prep the bracing

Make four sets of cross-braces. For each set, lay two 2×4s on top of each other with the ends lined up. Measure from one end and drive a 3" screw through both boards at the center mark from this chart:

BlindTower height2×4 lengthCenter screw mark
6' & 7'12'10'43 ½"
6' & 7'10'9'40 ½"
6' & 7'8'8'37 ½"
5'12'10'32"
5'10'9'30 ½"
5'8'8'29"

Step 4 — Spread into an X and fasten

Open each pair into an X and fasten it to two posts. The end you measured from goes nearest the floor. Brace all four sides the same way.

Step 5 — Flip it upright and level the floor

With all four sides braced, turn the floor and tower right side up. Adjust the posts with a level until the floor is level. A level floor makes every step of the blind assembly after this easier.

Then build the blind

From here the wall panels, roof, trims and windows go on in order. The full illustrated sequence (steps 6–17), the PDF manual and the video are on the setup page.

Safety notes

  • Do not build alone. A wall panel catches wind like a sail; pick a calm day and get a second person.
  • Check the ground under the legs every season. Frost heave moves posts.

Rather not build one? See the aluminum tower and the trailer kit (a 5' tower on a towable chassis) on Towers & Accessories. Both are for side entry blinds only and are sold through dealers.